Lift manufacturer: goods adjustment loading and unloading lift operation precautions

Release time:

Sep 26,2022

  The elevator manufacturer stated that if there is a common fault of hydraulic oil leakage during the use of hydraulic elevators, the treatment method is very simple. This is mainly due to damage or rupture of the hydraulic seal. In this case, only a stronger hydraulic seal of the hydraulic cylinder is needed. Another estimate is that the spare parts inside the hydraulic cylinder are damaged and may crack. At this time, simply replace the spare parts inside the hydraulic cylinder, Replacing hydraulic seals, for example, can also cause gas to enter the hydraulic system. At this time, it only needs to rise and fall a few times to clear the air inside the hydraulic cylinder; The hydraulic lift did not release pressure, but the large truck lowered. This may be due to residue in the hydraulic oil, causing the pressure relief valve to be unable to close. At this time, just replace the cleaned hydraulic oil. Another possible reason is that the pressure relief valve has not been adjusted, so it is necessary to adjust the pressure relief valve.

  Elevator manufacturers have stated that the rapid development of goods lifting service platforms is already in a peak period, as most manufacturers or individuals are more likely to use high-rise buildings in order to ensure site utilization, and therefore require equipment to conveniently improve and lower goods. Due to the high cost and low load-bearing capacity of general elevators, they are not suitable for carrying tens or hundreds of tons of goods. Therefore, high load-bearing capacity adjustable loading and unloading platforms, hydraulic elevators, and hydraulic lifting cargo elevators have been developed for quota proportion method and freight transportation.

 

  Precautions for operating the cargo adjustment loading and unloading elevator:
  1. The application of elevators requires specific staff members of the company (registered with the Human Resources and Security Department) to actually operate and abide by their positions; Non specific staff members are not allowed to use it privately.
  2.Before opening the elevator, first check whether the doors on each floor are closed and whether the emergency stop switch is calibrated. (The emergency stop switch is calibrated and rotated clockwise) Check the side of its emergency stop switch. After completion, the actual operation can be carried out.
  3. It is prohibited to ride on hydraulic elevators.
For example, if the cargo capacity of a hydraulic elevator is 3000kg, it cannot be overweight.
  5. When using elevators to transport products left and right, try to place the products in the middle of the elevator car as much as possible to prevent the products from tilting and getting stuck during operation, and the service platform should not be operated when the product accumulation is unstable.
  6.When the service platform encounters abnormal conditions during use, the operators should temporarily stop the operation of the service platform and report to the enterprise management department for dispatching troops for maintenance; System malfunction not cleared, disabled, and listed as a warning.
  7. After the application of the hydraulic elevator is completed, the operator will park the service platform at the bottom, close the landing door, turn off the main power switch of the lock key, and turn off the power of the main host.