DOWNLOAD LIST

Planetary reducer product selection

68.4MB

QTM Series 2015 Version

33.5MB

KSRF Series Helical Gear Reducer 2022V11

49.2MB

2021 Edition WS Series Manual

42.3MB

2021 Edition RV VF Series Manual

22.1MB

2021 Edition WP Series Manual

58.5MB

< 1 >

FAQ

Q

What are the advantages of some ground gears?

A
Some of the advantages are: Hardening and grinding gears 1. Noise 2. Maximum efficiency 3. Higher load capacity 4. Curved... Longer service life
Q

Is the worm gear reducer "self-locking"?

A
A worm gear set is considered to be self-locking, or irreversible gear when it cannot be worms. If this condition is established that the angle of the leading bug is smaller than the friction angle, the driving efficiency for reverse driving is zero. Factors such as the angle of friction under static conditions will change and the surface finish and lubrication. Generally accepted value base
Q

In the application will it be advantageous to use synthetic lubricants in the gearbox?

A
Most synthetic lubricants have lower pour point, high vibration resistance, and accept additives than conventional oil and gas equivalents. Therefore, a gearbox under one of the following conditions will benefit from the use of artificial lubricants: hot or cold ambient temperature; they carry an unbearable burden; continuous responsibility; or limited points.
Q

What are the two main reasons for the failure of premature gear reducers?

A
Some of the most common reasons include failure of the reducer selected for the application, changing the motor horsepower or speed, incorrectly aligning the joints, improper operation or insufficient lubrication, and lack of regular maintenance and repairs.
Q

What is hand driving?

A
The position on the output shaft relative to its reducer input shaft is called the configured hand. This is generally called right-handed (J), left-handed tendencies (G) or left and right-handed (H) if the output shaft is double extended.
Q

When do you use helical gear reducers and worm gear reducers?

A
When do you use helical gear reducers and worm gear reducers?
< 1 >